Greentent - World's First Portable Green House With Arduino Temp and Humidity Measurement

I first came up with the idea of a portable greenhouse you can move around at night when I wanted to make a way to have a small garden in a box with monitored Temperature and Humidity.

So, its late at night and I want to go to a store to get these supplies, so I manage to get my mom to bring me at night.

We got the supplies and I started to research.

It took me a while to get the right code and right schematics due to wire shorts, but I eventually cracked the code and here I am sharing this/it with you guys here at Robotics World!

Supplies:

A plastic box with a hinge

Plants that fit the box ( your choice )

Mist spray to control inside temp (optional)

Arduino UNO

LCD screen

DHT11 sensor

Jumper wires

(Arduino) Breadboard

---

Step 1: Schematics!

OK, so now that you're ready with the supplies and etc, make sure you follow ALL the steps that are shown in this schematic, I had a few wire shorts but then I figured it out after having the right pin placement.

---

Step 2: Code!

1. Here's the code! : https://pastebin.com/hV5JVhBx
   

---

Step 3: Finishing Touches and Final Steps

Awesome! You are almost done! Now, make sure you have a good space to light in. In my project, I added a mist bottle with tubes connected to the greenhouse to "transport" water to the greenhouse, and also I used mist to keep the humidity the way I liked it. * I CONNECTED THE BREADBOARD ON TOP OF THE BOARD SO THE LCD SCREEN IS VISIBLE * But really though, you choose where to place the electronics. Feel free to use my placement as an example!